If thicker layers are necessary (> 2 cm) the mortar can be mixed with kiln dried quartz sand. The mortar can now be over coated with EpoxyShield® coatings or other non-alkyd paints like Epoxies, Acrylics, etc. After 48 hours the surface can be sanded using a rough sandpaper (P120) to obtain a smooth end result. Wet the trowel to smooth out any trowel marks or irregularities. Add some water to your liking if the mortar is too dry.Īpply the product with the included trowel or spatula up to a maximum layer thickness of 2 cm. Mix water and powder thoroughly to a thick smooth, lump-free substance. Add the dry mortar to the water whilst stirring. Mixing ratio: Approximately 5 parts of powder to 1 part of water (2 litres of water for the entire 10 KG).įill the container with the water. Metal parts are to be treated with an anti-rust primer (Combiprimer 3369/3380 or Hard Hat 2169/2182). Porous substrates must be moistened first. The substrate must be solid and free from dust, oil and grease. On bare substrate: clean with steel brush or sand blaster. For leveling and repairing cracks, holes and other damages in concrete, cement renderings and unpainted brickwork. Rust-Oleum EpoxyShield Concrete Repair Mortar is a powdered repair product on cement base and resins for inside and outside use. Rust-Oleum EpoxyShield Concrete Repair Mortar With excellent results.For levelling and repairing cracks, holes and other damages in interior and exterior concrete, cement renderings and unpainted brickwork. Well worth the money and work doing this. This can be seen by a search of dave20thmay. I have done a small video on "You Tube" of my job of putting down this second coat. I left a small stepladder on it after a few days of drying and one of the rubber feet had just stuck to the what look hard paint. So although it felt hard to a thumb nail, don't leave something hard/heavy on it for a least a week. The weather when I did the painting was just nearly to cold. Plenty to spread around and to hold the decorative chips. Now the next tin, already having an undercoat, was very different. fortunately I was eligible for a 10% discount from TooledUp. So by rolling out a bit thin, the decorative chips did not have enough paint depth to attach itself properly. My garage floor was 22 sq.mtrs and the tin said it would do 25. I found that my first tin did not go as far as I thought it would. i was just exploring option for an upcoming project in spring. Ii have no links with the company at all. Thanks for the request and hope this helps." It's always worth noting that when a temperature is an ambient x concrete floors (especially during winter) are lower as they take large amounts of time to warm up to the ambient, usually they are a few degrees below this. The absolute min i would apply the product at is 10 degrees c as it's the temperature that enables the chemical cure, and any lower and this won't happen properly giving problems such as not drying in the times stated, not drying fully at all, or if dries will loose some of it's abrasion resistance in the future years and months. "the temperature is about right for application, once the product is cured it is fine down to temperatures of zero and below. Response from eu technical director to the wuetion raised about temperature. Not a review, just an addition to the review suggesting this product was not suitable for ambient temperatures below 16 degrees.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |